Confirm your controller
Record your autopilot model, firmware version, available UART/CAN ports and power budget.
RESOURCES & SUPPORT
Build with
the right details.
Resources for BEXFLY flight-control and GNSS integration, including the RTK + 4G development concept.
Before you connect.
Check your operating region
Identify correction service coverage, cellular availability and any service account requirements.
Verify the integration
Wait for a released pinout and supported firmware. Confirm cables, antennas, bus termination and compass calibration.
COMMON QUESTIONS
A few things to know.
Is the RTK + 4G concept available to purchase?
The module is currently presented as a development concept. Final pricing, delivery dates and ordering details are not yet published.
Is centimeter-level accuracy guaranteed?
No validated accuracy specification has been released. Results depend on receiver selection, antenna design, correction quality, environment and completed system testing.
Will I need a local base station?
The planned network correction architecture can remove the need for a local base in supported conditions. Correction service coverage and cellular connectivity remain necessary.
Can I use my existing GPS cable?
Do not assume compatibility. The proposed six-pin UART2 signals differ from a basic GPS/I²C interface. Use only the final approved pinout and matching harness.
Where are the downloads?
Firmware, pinout diagrams and production manuals will be listed when released. This site does not provide pre-release wiring or firmware files.
PROJECT INQUIRY
Tell us about
your next build.
Create a concise requirements brief to share with your BEXFLY contact.
This tool prepares a brief on your device. It does not send or store your information. A public sales contact has not yet been published.